Skip to content
Oil and Gas- Upstream/ Maintenance Operations

OPITO Vocational Qualification 3: Oil and Gas Engineering Maintenance (Instrument & Control)

OPITO Qualification

Product Code: Q000033

Who is this Product for?

This vocational qualification consists of the nine units below, two of which which must be successfully completed from Group 1 and a further three from Group 2:

Group 1

  • OGOS – M16: Diagnose Maintenance Requirements of Instrument & Control Oil & Gas Plant & Equipment (Process Control Systems & Equipment)
  • OGOS – M17: Diagnose Maintenance Requirements of Instrument & Control Oil & Gas Plant & Equipment (Process Measurement Systems & Equipment)
  • OGOS – M18: Diagnose Maintenance Requirements of Instrument & Control Oil & Gas Plant & Equipment (Protection & Detection Systems)

Group 2

  • OGOS – M10: Adjust and Optimise the Performance/Condition of Instrument & Control Oil & Gas Plant & Equipment (Process Control Systems & Equipment)
  • OGOS – M11: Adjust and Optimise the Performance/Condition of Instrument & Control Oil & Gas Plant & Equipment (Process Measurement Systems & Equipment)
  • OGOS – M12: Adjust and Optimise the Performance /Condition of Instrument & Control Oil & Gas Plant & Equipment (Protection & Detection Systems)
  • OGOS – M13: Carry out Maintenance on Components of Instrument & Control Oil & Gas Plant & Equipment (Process Control Systems & Equipment)
  • OGOS – M14: Carry out Maintenance on Components of Instrument & Control Oil & Gas Plant & Equipment (Process Measurement Systems & Equipment)
  • OGOS – M15: Carry out Maintenance on Components of Instrument & Control Oil & Gas Plant & Equipment (Protection & Detection Systems)

What does this Product cover?

The expected level of performance, knowledge, understanding and behaviour an individual must achieve when carrying out instrument and control engineering maintenance in the workplace.

Entry Requirements

Entry is at the discretion of the OPITO

Learners should be in a job or placement where they are carrying out relevant tasks and responsibilities which allow then to gather the required evidence.

It is recommended that learners complete the OPITO Vocational Qualification 2: Oil and Gas Engineering Maintenance (Instrument & Control)

or equivalent before undertaking this Vocational Qualification.

Product Achievement Requirements

To achieve the OPITO Vocational Qualification 3: Oil and Gas Engineering Maintenance (Instrument & Control) learner needs to complete two units from Mandatory Group 1 and three units from Mandatory Group 2.

If you require further information about our Global Qualification, or would like to discuss your requirements with a member of the OPITO team, please contact the Products Team in the UK office.

Centres delivering this product

Displaying 1-2 of 2