OPITO Global 1 Training Certificate: Basic Maintenance Practices (Instrument and Control)

This training certificate is aimed at learners with very little prior experience of an engineering workshop environment. 

The training certificate consists of the eight mandatory units below, all of which must be successfully completed, as required to achieve the OPITO Global 1 Training Certificate: Basic Maintenance Practices:

•OGTS – M06: Basic Health and Safety in Maintenance Workshops

•OGTS – M07: Basic Maintenance Techniques and Workshop Practices

•OGTS – M08: Basic Maintenance Hand Tools

•OGTS – M09: Basic Measuring and Marking-out Instruments

•OGTS – M10: Basic Engineering Communications

•OGTS – M11: Basic Numeracy Skills

•OGTS – M12: An Introduction to Physical Science and Basic Properties of Materials

•OGTS – M13: An Introduction to Electrical and Electronic Principles

In addition, the three following units must be successfully completed:

•OGTS – M14: Process Measurement Systems and Equipment

•OGTS – M15: Process Control Systems and Equipment

•OGTS – M16: Protection and Detection Systems.

There are no specific entry requirements, however, it is recommended that learners should complete the OPITO Global Foundation Certificate in Maintenance Workshop Practice or equivalent training before undertaking this training certificate.

The training certificate consists of one mandatory group containing eight units, and a further mandatory group unit containing three units. All units from each group must be successfully completed to achieve the OPITO Global 1 Training Certificate: Basic Maintenance Practices (Instrument and Control).